Classic Shell

custom start button icon does not appear correctly
Page 1 of 1

Author:  wombledung [ Fri Jan 06, 2017 12:05 am ]
Post subject:  custom start button icon does not appear correctly

i'm running windows 10 on a jolly nice PC.
i recently installed classicshell and like how it runs so far.

however, an issue has arisen so far.

i added my own custom start button icon (50x50 pixel png image).
the icon appears to be added successfully, but only a little 4mm rectangle along the top of the icon actually shows as if some one is holding a dark peice of card along the bottom half.

it makes the button look really shoddy and cruddy.

any ideas how this may be resolved? or any troubleshooting it can do?

i have just tried another image at 50x50 pixels, and a similar thing happens, and i have also noticed that the top half of the image appers to the bottom of the task bar, and when i hover over it, the bottom half appears at the bottom of the task bar.
why the hell is this annoying issue happening? is there a setting i have not noticed or understood?

Author:  Gaurav [ Fri Jan 06, 2017 1:09 am ]
Post subject:  Re: custom start button icon does not appear correctly

This is how the button should be: ... orial.html (with three states).

By default the width of the Start button equals the width of the image. The height of the button is the height of the image divided by 3. You can scale the image by overriding the width of the button from the Classic Shell settings. The height will be adjusted to preserve the aspect ratio.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group